Chapter 2 Glove Implementation 69 Assembly

2-7 Assembly

2.7.4 Printed circuit board

This section will shows PCB designs and schematic of the circuit .
the circuit which we use is the voltage divider circuit (see figure
2.3.3) but not only for one sensor but for all the flex sensors we use
and also it combined the 5 pins to connect the MPU-6050 module
with the Arduino and reserve the balance of the circuit.

By using the ISIS Proteus 7 professional we design the schematic of the circuit of voltage divider and pins of the accelerometer plus
additional part of analog multiplexing will be further discussed in
chapter 4.

And by using the ARES of Proteus 7 professional we have the design of the Printed circuit board ready to be printed.

Next figure shows the schematic of the circuit